Gasket sheets BELPA CSC - 120 are manufactured with a mix of carbon and aramid fibers in a matrix of high quality synthetic rubbers. This material has a very good mechanical resistance and an acceptable resistance to steam. This material is suitable for a wide range of industrial services.

 

PRESSURE-TEMPERATURE DIAGRAM	P-T OPERATING GUIDELINES
	1- Usually satisfactory to use without reference to Montero. Technical examination is normally unnecessary. 2- Must refer to Montero for advice. A technical examination is recommended 3- Area not recommended. The P-T diagram helps the user or designer who often knows the operating temperature and pressure to carry out an initial selection of a suitable material . The P-T diagram cannot guarantee the suitability of a material for an application.
Good performance and long service life of gaskets depend in large measure on fitting and operation conditions, over which the manufacturer has no control. The data given on this technical sheet should not be used as application limits, but as guidance for an appropriate choice. We can offer guarantees only for the quality of our products.
CREEP DEFORMATION / HOT CREEP TEST
Temperature increase Fyesa laboratory Thickness decrease SEPTEMBER 2001 CREEP DEFORMATION: percentage loss of thickness over a specified time under constant load, applied at a specified rate, at a specified temperature. Creep (%) = (loss of thickness under load at a specified time / initial thickness of the sample) x 100 Creep deformation gives an indication of the effect of time and temperature on deformation behaviour of gaskets materials. This parameter also gives an indication about the trend of a gasket material to leak in combination with the variables that also affect to a flanged union